Open new windowRecommend selecting the PDF printerSee all data sheets

IBERPAN E-Z
TECHNICAL DATA-AVERAGE VALUES
Rev: 02/04/2009
PROPERTIESTEST METHOD UNITS THICKNESSES mm
>30/45>45/60>60/70
DENSITY (*)EN 323kg/m3700/680675/640610
INTERNAL BONDEN 319N/mm20,550,500,50
BENDING STRENGTH EN 310N/mm2201716
MODULUS OF ELASTICITY EN 310 N/mm2200018001700
THICKNESS SWELLING 24 H EN 317%866
DIMENSIONAL MOVEMENT LENGTH/WIDTH EN 318%0,250,250,25
DIMENSIONAL MOVEMENT TICKNESS EN 318%555
SURFACE SOUNDNESS EN 311N/mm21,21,21,2
SURFACE ABSORPTION (TWO FACES) EN 382-1mm>150>150>150
MOISTURE CONTENT EN 322%7+/-37+/-37+/-3
GRIT CONTENT ISO 3340 % Weight≤ 0.05≤ 0.05≤ 0.05
FORMALDEHYDE CONTENT EN ISO 12460-5mg/100 g≤ 3≤ 3≤ 3
SCREW HOLDING. EDGEEN-320N700700700
SCREW HOLDING. SURFACEEN-320N100010001000
TOLERANCE ON NOMINAL DIMENSIONS
PROPERTIESTEST METHOD UNITS THICKNESSES mm
>30/45>45/60>60/70
THICKNESS EN 324-1mm+/-0,3+/-0,3+/-0,3
LENGTH/WIDTH EN-324-1mm+/- 2 mm/m max +/- 5 mm.+/- 2 mm/m max +/- 5 mm.+/- 2 mm/m max +/- 5 mm.
SQUARENESS EN 324-2mm/m+/-2+/-2+/-2
EDGE STRAIGHTNESS EN-324-2mm/m+/-1,5+/-1,5+/-1,5
(*) VALUES TO BE CONSIDERED AS A ROUGH GUIDE ONLY.

These physical-mechanical values improve/comply with those established in EN 622-5:2009 European Standard, Table 3. Requirements for boards used in dry environments.

IBERPAN E-Z meets Class E1 requirements (analysed according EN120) as defined in EN 622-1:2003 European Standard.

IBERPAN E-Z bears Certificate of Conformity with CARB phase 2 requirements, regarding formaldehyde emission limits.

The quality of IBERPAN E-Z is endorse by AITIM Quality Labels: 9-3-03.

IBERPAN E-Z STRIP meets the physical-mechanical characteristics described in this technical data sheet.

(SELECT)
Google+
Google+