Open new windowRecommend selecting the PDF printerSee all data sheets

FIMAPLAST H BKE
TECHNICAL DATA-AVERAGE VALUES
Rev: 08/12/2008
PROPERTIESTEST METHOD UNITS THICKNESSES mm
10/13>13/19>19/22
DENSITY (*)EN 323kg/m3720/680675/650640/625
INTERNAL BONDEN 319N/mm20,450,450,40
BENDING STRENGTH EN 310N/mm2181614
MODULUS OF ELASTICITY EN 310 N/mm2255024002150
THICKNESS SWELLING 24 H EN 317%111010
MOISTURE CONTENT EN 322%8+/-38+/-38+/-3
SWELLING IN THICKNESS AFTER CYCLIC TEST (V313)EN 321 / EN 317%111110
INTERNAL BOND AFTER CYCLIC TEST (V313)EN 321 / EN 319N/mm20,250,220,20
TOLERANCE ON NOMINAL DIMENSIONS
PROPERTIESTEST METHOD UNITS THICKNESSES mm
10/13>13/19>19/22
THICKNESS EN 324-1mm+0,5/-0,3+0,5/-0,3+0,5/-0,3
LENGTH/WIDTH EN-324-1mm+/-5+/-5+/-5
SQUARENESS EN 324-2mm/m+/-2+/-2+/-2
EDGE STRAIGHTNESS EN-324-2mm/m+/-1,5+/-1,5+/-1,5
COATING PROPERTIES
PROPERTIESTEST METHOD UNITS THICKNESSES mm
POROSITY INTERNARatingSin porosidad
CURE GRADEINTERNARating5
WATER STEAM RESISTANCE.UNE-EN 14323Rating5
RESISTANCE TO STAININGUNE-EN 14323Rating5
 
RESISTANCE TO ABRASION:TEST METHOD CLASSIP NUMBER OF TURNS
=UNE-EN 14323
4
>350
(*) VALUES TO BE CONSIDERED AS A ROUGH GUIDE ONLY.

The chipboard used in the manufacturing of FIMAPLAST H BKE meets Class E1 requirements (analysed according EN 120) as defined in EN 312:2003 European Standard.

(SELECT)